Hickory Hardware Convection Oven N 5.5 E User Manual download pdf (Page 15)

4900 Westside Avenue, North Bergen, New Jersey 07047

Tel: [201] 223-0050 Fax: [201] 223-0950

Hickory Industries, Inc.

N/5.5E Installation 8/5/97

Page 15 of 15

If the glass is not evenly spaced, adjust the glass until

its evenly spaced.

CAUTION: If the screws are not snug enough, when

lowering the glass door, the glass my hit the screws

and chip the glass.

CAUTION: When tightening the screws, if the glass

shifts down, the glass door will be too close to the

roof of the machine when the glass door is shut.

Open door and tighten upper mounting screws.

Close the door and verify that the side and bottom

spacing is even all around.

Make sure all screws are tight and have been replaced

using hi heat Loc-Tite.

Return equipment back to operating condition.

Caution

Operators should not use a razor blade

or knife to clean the glass.

Glass should not be cleaned with abra-

sives, soft scrub or any pad, i.e. Brillo,

Scotch Brite, scouring pad etc. This

will scratch the glass and render the

glass faulty.

Tempered glass will break if scratched,

shipped or mishandled in any way. It

can break in a day or a year. BUT IT

WILL BREAK.

Left Blank Intentionally

Column 5

1 2 ... 10 11 12 13 14 15

No comments

Hickory Hardware Convection Oven N 5.5 E User Manual Page 15